3
Safety Introduction
interference.
Note:
In order to help you use the equipment, the following considerations can help
avoid the occurrence of problems that may damage the components or cause data
loss etc.
1.
In case of the following cases, please unplug the power line plug of products
from the power socket and contact customer service department of Inspur:
1)
The power cables, extended cables or power plugs are damaged.
2)
The products get wet by water.
3)
The products have fallen off or been damaged.
4)
Objects fall into the products.
5)
When operating according to the operation instructions, the products cannot
function normally.
2.
If the system becomes damp, please dispose according to the following steps:
1)
Switch off the power supplies of the system and the equipment, disconnect
them with the power socket, wait for 10 to 20 minutes, and then open the
cover of the host.
2)
Move the equipment to the ventilation place to dry the system at least for 24
hours and make sure that the system is fully dried.
3)
Close the cover of the host, re-connect the system to the power socket, and
then start the equipment.
4)
In case of operation failure or abnormal situation, please contact Inspur and
get technical support.
3.
Pay attention to the position of the system cables and power cables, wire them
in places not to be stepped on or knocked down and ensure not to place other
objectives on the cables.
4.
Before dismounting the cover of host or contacting the internal components, you
shall cool down the equipment first; to avoid damaging the main-board, please
power off the system and wait for 5 seconds, and then dismount the components
from the main-board or disconnect the connection of peripheral equipment of
the system.
5.
If there are modulator-demodulator, telecommunication or local area network
options in the equipment, please pay attention to the following matters: