Device Setup
3/18/15 06443E © 2015, Inovonics - www.inovonics.com
34
Note:
The supervision window is the period of time during which the EN6080 must hear
a check-in message from the end device or consider it inactive. For instance, if a
device is set with a supervision window of 540 seconds and 540 seconds elapses
without the EN6080 hearing a check-in message, then the device will be
considered inactive. A good rule of thumb is to set the supervision window at a
minimum of ten times the device’s check-in rate. Most Inovonics security products
have a check-in time of three minutes, or 180 seconds.
Note:
When you enter the supervision time for the first listed device, it will automatically
populate the supervision field for all other listed devices. If this is desirable, no
further input for supervision time is needed. If not, you can overwrite devices with
different supervision times.
8.
When you have edited all devices, click “Register.”
6.2.3 Unregister a Registered Device
To unregister a registered device:
1.
Click the checkbox next to the registered device you wish to unregister.
2.
Click “Unregister.”
3.
Click “OK” to confirm.
6.3 Upload Administration
The upload administration screen is used to register Inovonics end devices
and repeaters by uploading a spreadsheet with the transmitter information
already entered. The file needs to be a comma delimited text file, and each
device to be registered needs to be a separate line in the following format:
TX ID, Type, Description, Supervision Window, Reserved1, Reserved2,
Reserved3
• TX ID is the unique serial number for each Inovonics end device. The
serial number can usually be found on the printed circuit board of the end
device.
