13
13.
MAINTENANCE
Disconnect the electrical connection of the appliance
immediately before beginning maintenance or cleaning
activities.
Before the first use, the electrical connection of the
appliance must be disconnected and it must be cleaned
with warm soapy water.
Water must definitely not be sprayed or spilled on the
appliance.
Clean the appliance at the end of each working day
with a piece of cloth soaked with warm soapy water
and with a disinfectant that will not harm nutrition
products (especially the areas in contact with meat).
Pins and tray plate contacted by the meat may be
washed in the dishwasher.
Do not use materials that can scratch the surface such
as detergent with abrasive ingredients, wire brushes,
etc. when cleaning the surface of the appliance.
If the appliance will not be used for a long period of
time, the surface should be coated with a thin layer of
Vaseline.
Notify the authorized service if the appliance is
considered in a dangerous situation. Do not allow
incompetent persons to interfere with the appliance.
Contact manufacturer when the maintenance period of
the appliance has expired and/or when the appliance
has a fault.
WARNING:
Do not clean the appliance with
directly or with high-pressure water. Otherwise
you may cause an electrical installation
malfunction.
9. TRANSFORMATION FOR DIFFERENT
GAS TYPES
Refer to table “T1” for adaptation to different gas types.
Choose the injector suitable for the gas type and pressure to be
used from table “T1” and install it to the housing of the
removed injector.
Label for the new gas type shall be affixed by removingthe
current label after adapting the appliance to a different gas
type than the gas type set by the manufacturer.
9.1 Replacement of Injector
Select suitable injector from table T1.
Remove the rear plate of the appliance.
(1) Face the radiant. (2) Remove the pin on the radiant.
(3) Remove injector from the radiant. (4) Replace with
new injector and install the new injector to the same
housing. (5) Install the pin as you have removed it. (6)
Gas type transformation is complete.
Injector diameters are printed on the injectors.
8.1 Cleaning of Robax Glass and Storage System
Apply a few drops of suitable cleaning agent and wipe
with paper towel or clean soft cloth when the
surfaces of Robax glass and casing system
have cooled down.
First clear splashed food or burnt residue from the
surface of the ROBAX glass and storage system
with a suitable scraper.
Do not use abrasive sponges or any scrubbing
material.
Proper cleaning agents are all cleaning agents that
may be used for Robax glass ceramics.
