3
pressing and HOLDING both interface buttons together will move
you to the menu or main screen. The gauge will revert back to the
main screen if no there have been no button presses for 15 seconds.
-
From the main screen, pressing and HOLDING both the left and right
interface buttons will disable/enable solenoid control. If there are no
other error codes on the status viewport of the screen, the SCG-1
will display “SC OFF”.
-
From the Peak boost display, press and HOLD the right interface
button to clear the stored peak boost value.
4. Shift
Light
-
Illuminates when the trigger shift RPM is reached.
1.1
Changing the SCG-1’s gauge face and/or bezel
1. Lay the SCG-1 face down and remove the three #2 phillips screws
from the outside rim of the back plate.
2.
3. Configure the gauge as desired by changing the gauge face and/or
bezel.
4. Make sure every piece is positioned correctly using the locating tab
and reassemble the gauge.
