11
2.
Power up the SCG-1.
3.
Launch
LM Programmer.
The LM Programmer application can be
launched from
Start->Programs->LogWorks3->LM Programmer
from
the Windows task bar.
Once you have completed your desired changes, press the
Program
button
on the lower right on the software application. You will know that the SCG-1
has been programmed successfully when the
Program
button grays out.
3.2
Display Settings (Gauge Abbreviations)
1. Wideband O2 Units (WB O2 Units)
– Allows the gauge to display
O2 units in either AFR or Lambda. Default setting is AFR.
2. MAP Units -
Allows the gauge to display pressure in either
inHG/PSI, kPa or BAR. Default setting is inHG/PSI
3. Enable Wideband O2 (WB O2 State) –
Allows the wideband to be
disabled or enabled. Also indicates the sensor type used (sensor
type can only be changed by connecting the SCG-1 to LM
Programmer.)
NOTE: If the wideband is disabled, the O2 sensor
should be removed from the exhaust to avoid damaging it.
Default
setting is O2 enabled.
4. Fuel Type –
Change to different fuel types when SCG-1 is setup to
display in AFR. Default setting is Gasoline.
3.3
RPM Settings (Gauge Abbreviations)
1.
Mode (RPM Mode) -
Select how many pulses per rotation (ppr)
based on your tach signal source. When setting up Mode using the
gauge interface, you will also see a real-time display of the RPM to
ease the setup. Default is 1 pulse per rotation.
2.
Scale (RPM Scale) –
Select either 10230 or 20460 RPM scales.
Default is 10230
3.
Shift RPM –
Set to desired RPM to trigger illumination of the shift
light on the SCG-1. Default is 10230 RPM.
3.4
Solenoid Settings (Gauge Abbreviations)
In an O2 error state, all solenoid functions are automatically
disabled. To continue using the solenoid functions without
the safety cuts, the wideband function of the SCG-1 may be
disabled from the setup menu.
