InisBofin Insert Boiler Multi-fuel Stove
5
Figure 3 below shows the stove
damper controls.
Fig.3
The stove has been designed for
ease of use by the operation of
just one air control slider. The
damper slider governs all the air
flows throughout the stove for
optimum efficiency and
performance. This adjustment
slider is found on the right side
of the stove towards the top of
the facade. To operate the damper
slider, use the hand tool to move
the slider downward fully to close
the damper and upward to open the
damper. No adjustment of the
damper assembly is necessary. To
help keep the stove glass clean,
use kindling which lights quickly
and fire the stove at a high rate
for 45-60 minutes after lighting
to fully heat the glass. Operating
the stove for extended periods of
time at low outputs will lead to
blackening of the glass.
Paint Curing
Please adhere to the curing
procedure described below as over-
firing the stove before the paint
has cured will lead to fading of
the paint and this is not covered
by your warranty.
When the stove is used for the
first number of times the process
of curing the paint will occur. To
do this a small fire using only
kindling wood should be started for
approximately 30 minutes, allow the
stove to cool slightly then repeat
the small fire using only kindling
wood for another 20 minutes. The
final action to cure the paint is
to put on a normal sized fire
before the stove has cooled down,
at full output for at least one
hour. The stove paint will emit
fumes which are non-toxic but a
window should be opened to avoid
fumes building up during the curing
process.
Before you operate the stove,
consult with the installer that all
the relevant work has been carried
out correctly and that they have
ignited a small fire in the stove
and it is operating correctly.
Check that all relevant local,
national and European Standards
have been adhered to when
installing the stove.
