Installation and programming manual
Configuring the loop
45
1. Select the address that corresponds to the physical position of the device (an assigned or unassigned
address), press
Ok
2. Press
S
or
T
to select the address and device type.
Note:
To remove a point, enter ‘0’ in the "Type" programming field.
Once the points have been added, you must complete their programming (refer to paragraph 11.1 -
Programming fire-detection points
).
10.3
Configuring the devices
Refer to
Appendix A
,
Appendix B
and
Appendix C
.
10.4
Checking enrolled/addressed devices
After initializing the enrolling procedure (for all devices) or the automatic-addressing process (only for
devices that accept this method), you must wait for its completion, then compare the number of enrolled
detectors/devices with the total number of detector/device placements.
If the totals differ:
1. Press
Ok
to access
Programming points
(refer to paragraph
11.1
).
2. Search the list for the devices that have not been found by the panel.
3. Clear the anomaly and re-initialize the addressing process.
If the totals match:
1. Press
Ok
to access
Programming points
.
2. Proceed with the programming process of all the points.
