WEB Configuration Manual
- 64 -
10.6 ERPS
Click
Redundancy -> ERPS
at navigation bar in order, and then enter the ERPS list configuration
page as following:
This page shows the configured ERPS ring, including ring ID, control vlan, Ring-Node version,
Ring-state, Signal Fail, WTR-time, guard time, send-time, primary and secondary port.
Click
Modify
on the right of the list, configure the time and primary and secondary port.
Click
Create
at the bottom control bar, create new ERPS ring.
Note:
1. This system only supports ERPS single ring configuration.
2. Max 8 ERPS ring node.
3. Once one ERPS has been configured, its ID, ring ID and control Vlan cannot be configured. If
these parameters need to be configured, please delete this ring and re-create it.
Click
Create
at the bottom control bar or click
Modify
on the right of the item, enter the ERPS
configuration page as following:
The ring ID of ERPS can be from 1 to 7.
After the port 1 and port 2 configured, the corresponding port role should be configured.
In the text boxes of “Port 1” and “Port 2”, select a port as the ring port respectively or select “None”.
Note:
Once one MEAPS has been configured, its ID, ring ID, ring type, node type and control Vlan cannot
be configured
