WEB Configuration Manual
- 32 -
For hosts that do not use DHCP to obtain addresses, users can manually add entries for binding at
the switch ports to enable the host to smoothly access to
the network. The “no” command can be
used to delete the binding entries.
Entries bound manually proceed over those bindings through dynamic configuration. If the MAC
address of the configured entry is the same as the MAC address of the dynamically configured
entry, the latter will be updated based on the former. The MAC address is the only one index for
binding entries of a port.
Click "Create" to create entries for binding manually configured DHCP Snooping ports.
Note
：
Binding entries can be created only if enabling DHCP Snooping protocol.
6.3
Access Control List
6.3.1
IPv4 Rules
Click
Network Security -> Access Control List -> IPv4 Rules
at navigation bar in order
to enter
IPv4 rules’ page as following:
Click
Create
to create an IP access control list.
Click
Delete
at the bottom control bar, delete the selected access control list.
Click
Detail
on the right of the table to enter the IP Access Control List page.
