Ingenium 2E2S, Technical Installation Manual, Page: 9 / 196

9
ingenium
www.ingeniumsl.com
N L
4 3 2 1
85V-250V~(50/60Hz)
Min. Adjust.
Nor
Min M‡x
17 1
7
2 13
SR
Microprocessor Supply
4: Neutral
3: Phase
1: Load
Detection
Direction of the device
Place lengthwise, with the length of the
device parallel to the length of the room.
Together with the programming, this will
ensure optimal detection.
Timer adjustment (Min.)
¥ The timer adjuster regulates the time a load
remains connected.
¥ Timers can be adjusted between 0.25secs (Pulse)
and 17mins, at 4sec intervals.
¥ Minimum timings are obtained by turning the
adjustment potentiometer clockwise.
Sensitivity adjustments (Adjust.)
¥ The sensitivity adjustment limits the degree of
detection.
¥ Maximum distances that can be reached will
depend upon the density of obstacles to penetrate
(wood, plaster, brick, etc.).
Detection area at
2.5m from the floor:
Guaranteed: 6x3m
Maximum: 12x6m
Detection area
The detection area must face the room,
with the silk screened part of the device
face-down.
Installation in a false ceiling
Floor
Guaranteed area 6x3m
Maximum area 12x6m
Length side of the room
SR output wiring
Power consumption 4.5mA
The device can be partially
blinded with metal tape to
cancel detection in a
zone/direction.
Do NOT install:
á In locations susceptible to vibrations.
á Over fluorescent lights.
·
SR
Installation