Ingenium 2E2S, Technical Installation Manual, Page: 150 / 196

150
software
The BUSing® Development System is used to configure BUSing® installations in residential locations, commercial areas,
and any major infraestructures.
This software is a powerful and intuitive tool for the installer/integrator who will be the responsible for programming
each device according to the funcionaliades required in the installation.
• Supports up to 65,500 node installations.
• Organizes the installation dividing into one main trunk and secondary branches where the nodes are distributed.
• Among its features includes individual addressing or programming of smart devices.
• Allows to configure the most advanced BUSing® visualization devices such as touch-screens and Web servers.
• This software automatically updates via the Internet when new versions are available.
Correct use and training
For proper management and to take advantage of all its features, avoiding incidents and errors in configuring any instal-
lation, the installer/integrator, user of this software, should be credited with a BUSing® Certificate that guarantees a cor-
rect use. The BUSing® Certificates are obtained by taking training courses that INGENIUM organizes periodically.
This software can store, control, find and analyse the diagnostic of each BUSing® device connected in an installation,
and registers the data that circles through the BUS, state of the devices, outputs status at every instant, etc.
Specially indicated to carry out a complete and rapid control of an installation, being able to detect any error efficiently.
·
Sniffer Packet
Diagnostic software
For the thorough control of a BUSing® installation.
·
SIDE
Configuration software
To configure BUSing® installations.