Ingenium 2E2S, Technical Installation Manual, Page: 52 / 196

52
ingenium
www.ingeniumsl.com
+12V
A
B
Ref.
Z2
Z1
IN2 IN1
á 2E2S
• 2 digital inputs
• 2 digital outputs with potential free relay
• Remembers last position when power fails
• Programmable inputs to work with switches or pushbutton
• 2 programmable BUS events for each input
• Size: 50 x 35 x 25mm
Description
The 2E2S is an on/off actuator equipped with 2 digital outputs with potential free relay with a switching capacity of 10A
per output and 2 digital inputs for low voltage (SELV) referred to the mass of BUS.
From the Development System (SIDE) is possible to assign sequences of 15 characters for each one of the outputs and
entries. You can also set the mode of operation of each of the inputs (button, switch or electric blinds mode), and two
BUS events for each input (one trigger event and one-off), allowing thus acting on any element of the installation from
the device inputs.
Inputs
• 2 digital inputs low voltage (SELV) 5V, minimum activation current 5mA.
• Active when connected to BUS mass.
• Maximum distance from device to switch or push-button, 30m.
• Configurable hardware and software filter through Development System (SIDE).
Outputs
• 2 digital outputs with potential free relay.
• Switching capacity 10A @ 230V AC per output. To control circuits with higher power interlay a contactor.
• Deactivated: Triac open. Activated: Triac closed.
Technical Characteristics
* potential free outputs
Device
Reference
2E2S
Voltage
Supply
9–16V DC (BUS)
Current
Consumption
80mA (BUS)
No.
Outputs
2* (relay)
Switching capacity
of each output
10A
·
2E2S
2 digital inputs and 2 digital outputs actuator
To control 2 electrical loads or 1 blind/curtain.
input /output