Ingenium 2E2S, Technical Installation Manual, Page: 166 / 196

166
communication
< other devices
• Signal Repeater with 2 BUSing® connections
• Size: 42 x 42 x 15mm (installed in distribution boxes)
Description
The REPing-T is a device that acts as a signal repeater, relaying data packets received, to achieve
greater cabling distances and allow a greater number of connecting devices to a single line.
Should consider the voltage drop in the cable for power supplies if needed.
Technical Characteristics
Device
Reference
ROUTing
REPing-T
Voltage
Supply
9–16V DC (BUS)
9–16V DC (BUS)
Current
Consumption
100mA (BUS)
15mA (BUS)
·
REPing-T
BUSing® signal repeater
Allows to prolong bus distances and the number of connected devices.
1
2
+12V A B Ref.
á ROUting
+12V
A B
Ref.
ingenium
www.ingeniumsl.com
• Coupling between main and secondary lines
• Selective management of traffic between secondary lines
• 2 BUSing® connections: 1 – principal line / 2 – secondary line
• DIN rail mounting (2 modules)
Description
The ROUTing is a device that attaches BUS secondary lines to a main line and allows selective
filtering of traffic to some devices.
The division of an installation in primary and secondary lines is very advantageous because it
allows separating data traffic local to each secondary line, without affecting the data sent to
other lines, furthermore allowing that in case of failure of one of them, only affected this line,
leaving the rest perfectly communicated.
Its use is recommended in installations with more than 150 nodes and essential in installa-
tions with more than 255 nodes.
Configuration using Development System (SIDE)
• Select the communication speed of main trunk (baud).
• Configuring the selective filtering of traffic nodes.
·
ROUTing
BUSing® line coupler
Allows to extend installations (up to 65,536 nodes)
+12V
A
B
Ref.
A
B
Ref.
+12V
ingenium
www.ingeniumsl.com
á REPing-T