SKYZER TECHNOLOGIES
PAGE 28 OF 147
INGENICO ICT2XX PTS2018 PAYMARK OPERATING MANUAL
Version 1.00
2.0
DIAL MODE?
1-TONE
2-PULSE
3-TONE/BLIND
4-PLUSE/BLIND
This parameter sets up the way that the terminal dials. Select the preferred mode
by pressing the corresponding number key.
1 = Tone
- is the default setting.
In the default dial mode setting
1
(Tone), the terminal uses DTMF tones to dial the
number, but only after de
tecting a valid NZ dial tone. If a valid dial tone isn’t
detected
, “Transmission Error” will be displayed.
2 = Pulse Dial
–
this communication setting is used for the older PABX systems
and is rarely used nowadays.
3 = Tone/Blind Dial
–
this is the same as Tone dial, however the modem ignores
the health of the dial tone on the line and simply dials the configured phone number
to call the host. This is used where the quality of the dial tone is low.
4 = Pulse/Blind Dial
–
this communication setting is used for the older PABX
systems and is rarely used nowadays.
3.0
PABX?
1A
or
1W
Press
ENTER
to bypass if no PABX prefix is required.
This parameter specifies the PABX numbers that the terminal dials to access an
outside line.
Note:
The terminal pauses for 1 second after dialling if a control character
‘A’
is
inserted or to pauses for couple of seconds after dialling if a control character
‘W’
is
inserted after the PABX number. To insert a control character
‘A’
or ‘W’
, press the
corresponding number key and then the
FUNC
key.
To remove a PABX number from the PABX field, press
1
and then press
FUNC
key
until space is displayed followed by
ENTER
.
4.0
HOST PHONE NO?
08797
This parameter specifies the phone number of Paymark network to dial to. By
default, the host phone number is set as
08797
. Press
ENTER
.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
5.0
SAVE CONFIG Y/N
Terminal prompts to save configuration. Press
ENTER
to save configuration on the
terminal or
CLEAR
to exit and return to idle screen.
5.1.2
TCP-IP with Dial Backup Configuration
1.0
IP PRIMARY
HOST PORT
33876
This parameter specifies the Primary TCP/IP Port Number of Paymark network. Press
ENTER.
