InFocus TD61, User Manual

Page: 21 / 102

19
Installing the Lower Retaining Bracket
The lower retaining bracket is not designed to hold the
weight of the display. Its function is to hold the bottom
of the display securely to the mounting surface and to
allow adjustment of the display to insure perpendicu-
larity.
• Attach the lower retaining bracket to the bottom of
the display with the side of the angled bracket with
the 4 slotted holes against the bottom of the display
and the other side between the display and the
mounting surface.
• Mark on the mounting surface to locate the bottom
and ends of the retaining bracket. Remove the
retaining bracket from the display.
• Remove the display from the mounting bracket.
• Install the Lower retaining Bracket to the mounting
surface with appropriate hardware and slots. Locate
the bracket on the mounting surface using the
locating marks made when it was on the display.
• Hang the display on the mounting bracket.
• Secure the display to the lower retaining bracket,
leave the screws a little loose to allow for adjust-
ment. Use the hardware provided.
• Do not push or pull the display to align it with the
slotted holes in the lower retaining bracket. If the
holes do not align, remove the retaining bracket and
repeat the steps to locate the bracket on the mount-
ing surface.
• Use a level or plumb bob to determine perpendicu-
larity. Move the bottom of the display either in or
out till the display hangs perfectly straight. Tighten
the screws on the lower retaining bracket.
Lower retaining bracket installed on the bottom
of the
TD61
. The adjustment slot is shown in the
blow-up picture.
Lower retaining bracket attached to mounting surface.
Downloaded from www.Manualslib.com manuals search engine