To ensure firing accuracy, please fix the Tube at a proper position on the weapon.
The Tube series needs to be fixed with an adapter clamp,
such as a simple Picatinny rail
clamp provided in the package.
The Tube series adopts a tubular body design with a
diameter of 30mm, which is compatible with standard clamps with a diameter of 30mm,
such as those of day scope. Proper tools can be used to install the Tube device according
to the supplier's installation suggestions and steps.
During installation, the installation position of the Tube device should be adjusted
according to the distance between eye and eyepiece (eye relief) as specified in the
specifications and the sense of use and comfort. If you fail to follow this suggestion, the
eyepiece may hurt the shooter during the shooting.
It is recommended to install the scope as low as possible, but keep it away from the barrel
or other devices;
It is recommended to use a torque wrench to tighten the screws of the installation clamps,
so as to avoid damaging the scope body due to being over-tightened, and the
recommended torque shall not exceed 2.5nm;
When the scope is used for hunting, please carry out the zeroing operation first
according to the instructions as specified in "
Chapter 9 "Zeroing"
in this manual;
When using the scope at night or in a dark environment, it is recommended to use an eye
cup to avoid being found.
Startup and Configuration
Opening the lens cap
(
14).
If the outdoor light is strong, you can close the lens cap to
prevent the image from overexposure
;
Press and hold the Power button (5) for 2s to power on the device. Then, the home screen
appears after 3s.
Adjust the resolution of the icon on the display by rotating the eyepiece focusing ring (2)
of the ocular lens;
Adjust the focus length by rotating the focusing ring (13) of the objective lens;
Setting the image mode: On the home screen, press the P button (6) to set the image
palette mode, which is day-night in sequence, and the icon on the top status bar is updated
