7
Chapter III Keyboard Operation and
Programming
This chapter describes the operation and programming procedures
for a matrix switching system. Please make sure that V2117
keyboard has been correctly connected to the matrix switching
system prior to operation or programming.
3.1 Keyboard Operation
To perform keyboard operation, access the Operate Mode by
placing the key switch in the OPERATE position.
Operation Mode Switching Shortcut:
Matrix RS232 Control Mode: USER + 1 (press and hold USER key
and then press numeric key 1);
Matrix Ethernet Control Mode: USER + 2 (press and hold USER
key and then press numeric key 2);
DVR RS485 Control Mode: USER + 3 (press and hold USER key
and then press numeric key 3);
DVR/NVR Ethernet Control Mode: USER + 4 (press and hold
USER key and then press numeric key 4);
4-digit Camera Number Display Mode: USER + 5 (press and hold
USER key and then press numeric key 5);
8-digit Camera Number Display Mode: USER + 6 (press and hold
USER key and then press numeric key 6);
12-digit Camera Number Display Mode: USER + 7 (press and hold
USER key and then press numeric key 7. Available for V2060 series
matrix switchers only.).
3.1.1 Keyboard LCD
1. At RS232 Matrix Control Mode
At 4-digit camera number display mode, the LCD will display as
follows:
SITE
MON
CAM
001
0005
Of which, SITE displays nothing; MON displays monitor number in
3 digits; CAM displays camera number in 4 digits.
Example: Switch camera number 89.
Enter “89” directly on the keyboard. The newly entered number will
be displayed on the bottom right corner of the LCD, as shown
below.
SITE
MON
CAM
001
0005
89
Then, press CAM key. The camera number on the LCD will be
updated as follows:
SITE
MON
CAM
001
0089
At 8-digit camera number display mode, the LCD will display as
follows:
MON:001
CAM:00012345
Of which, MON displays monitor number in 3 digits; CAM displays
camera number in 8 digits.
Note:
If the camera number is less than 5 digits, the LCD will
display as follows:
MON:001
CAM: 1234
At 12-digit camera number display mode, the LCD will display as
follows:
M:001
C: 000000011111
Of which, “M” displays monitor number in 3 digits; “C” displays
camera number in 12 digits.
Example: Switch camera number 89.
Enter “89” directly on the keyboard. The newly entered number will
be displayed on the bottom right corner of the LCD, as shown
below:
M:001
C: 000000011111
89
Then, press CAM key. The camera number on the LCD will be
updated as follows:
M:001
C: 000000000089
2. At Matrix Ethernet Control Mode
At 4-digit camera number display mode, the LCD will display as
follows:
SITE
MON
CAM
001
0005
@Y
219
Of which, SITE displays the last section of the remote site IP
