Infinity 880FL, Owner'S Manual

Page: 8 / 40

8 LT6387 Iss 4 (05/14)
880 FL Users Instructions
SECTION THREE Cleaning continued
To gain access to the pilot, please do the following.

Remove the two side covers LH and RH.

Undo the two M4 nuts retaining the glass fixing bracket using the tool provided then pull clear
and from the location studs.

Carefully lift the glass panel from within the
bottom location slot.

Remove the log fuel bed shapes and bark
shapes.

Lift out the air tray assembly from the location
points within the shelf.
The pilot is located on the right hand side of the
appliance, any debris in or around the aeration hole
should be remove using the nozzle of a vacuum
cleaner. It is advisable not to blow the debris into the
hole as this may cause more of a restriction and not
rectify the problem.
Note: - Take care when cleaning in this area so as not to damage the pilot assembly.
GLASS CLEANING
From time to time it will be necessary to clean the glass panel of your 880 FL. We recommend you
use a Ceramic hob cleaner these are available for all leading super markets: - i.e.
ASDA, TESCO,
SAINSBURY’S
Etc.
Brands of hob cleaning we have tested and found
suitable are -
HOB BRITE & VITRO CLEAN.

Ensure the fire as been turned OFF for at least four
hours to ensure it is cool.

Remove the glass panel as described below.

Lay the glass panel down on a flat working surface
on top of an old opened newspaper with the side to
be cleaned uppermost.

Follow the instructions on the Hob Cleaner Bottle.

On stubborn stains (where the appliance as been
used for a long period without glass panel being
cleaned), use a new Brillo Pad well wetted with the
Hob cleaner applied directly to it.

Ensure all the residues of the cleaner are removed with a damp cloth and the glass panel is
completely dry before fitting to the appliance.
Important: - The appliance must not be used if the glass panel is missing or damaged.
Note: - The glass may discolour quickly when first installed, and it should be cleaned. This is
due to the burning off process of the refractory fuel bed shapes.