Infinity 880FL, Owner'S Manual

Page: 20 / 40

20 LT6387 Iss 4 (05/14)
880 FL
Installation Instructions
SECTION SEVEN Regulations and Warnings

This appliance must only be installed in Great Britain or Ireland.

The appliance is suitable for use on natural gas only.

GB (Great Britain) This fire does not normally require purpose build ventilation in accordance
with 2010 document “J” Building Regulations.

IE (Ireland) Permanent ventilation must comply with the current edition of IS813.

In GB , (Great Britain)
It is the law that all gas appliances must be installed by a competent person; i.e. a GAS SAFE
registered installer, in accordance with the Current Gas Safety (Installation And Use) Regulations
(as amended), all relevant parts of the local and national building regulations and all relevant
recommendations of the following British Standards. Failure to do so could lead to prosecution.
The following are relevant codes of practice and British Standards: -
B.S. 5871
B.S. 5440 PART 1 & PART 2
B.S. 6891
This appliance must be installed to current versions of the above standards and include any
relevant amendments to:-
The Building Regulations Issued By The Department Of The Environment.
The Building Standards (Scotland) (Consolidated) Regulations Issued By The Scottish
Development Office.

IN IE, (Ireland)
The appliance must be installed by a competent person and installed in accordance with the
current edition of I.S.813 Domestic Gas Installation, the current building regulations, and the
current ETCI rules for electrical installation, if appropriate.

Prior to the installation ensure that the local distribution conditions (identification of type of gas
and pressure)and adjustment of the appliance are compatible (G20 @ 20mbar)or(G31 @37mbar)
WARNINGS

The glass front of the fire act as a dress guard, conforming to BS 1945 (1971) and satisfies the
heating appliance regulations (1991) However, a guard conforming to BS6539 (1984) must be
used to protect young children, the elderly or infirm.

This appliance incorporates a safety device in the form of an Oxygen depletion system. IT
MUST NOT BE ADJUSTED OR PUT OUT OF OPERATION! THIS IS A NON-SERVICABLE
ITEM AND MUST BE EXCHANGED AS A COMPLETE ASSEMBLY; USING ONLY THE
ORIGINAL MANUFACTURER'S PART.

A suitable proprietary fire surround with a 150°C minimum rating is required.

During initial firing, an odour may be evident. This is the starch binder used during the
manufacture of the fibre components of the fire, and there are no harmful effects produced.

Care must be taken to prevent any damage being caused to surrounding soft furnishing or decoration; e.g. many
embossed vinyl wall coverings may become discoloured if placed too close to the appliance.