Infinity 880FL, Owner'S Manual

Page: 23 / 40

23 LT6387 Iss 4 (05/14)
880 FL
Installation Instructions
SECTION NINE To Install the Appliance
GAS SUPPLY ROUTING
Use rigid or semi
– rigid tube to connect the supply. Determine
the gas supply pipe route to the appliance before installing the
fire.
Fixing Firebox Assembly

Slide the firebox into the fireplace open guiding the gas
supply pipe through the hole at the rear LH bottom of the
firebox.

Retain the Firebox using wall plugs and screw using the four
holes within the firebox flange.

Refit the grommet over the pipe and seal around
the inlet hole.

The Fireplace frame can now be located onto the
firebox assembly and retained using the six off M4
nuts provided.

Remove the gas connection cover located within
the burner shelf left hand side and connect to the
restrictor elbow provided.
Note: - The isolation valve must be fitted at a angle to
allow access to the restrictor plug plus gas pressure
test nipple.

At this point the fireplace or false chimney breast front will
need to be constructed.

Connect battery pack as described in section 2. (Operating
the appliance). Locate the battery pack in the holder
positioned within the fireplace frame.

Now check that a signal is being received by pointing the
remote control hand set in the direction of the appliance and
press ON / OFF Key for at least 2 seconds. On release a
bleep should be heard and the ignition process will start.