Inficon XL3000flex, Translation Of The Original Operating Instructions

Page: 31 / 108

INFICON Installation | 5
XL3000flex-Operating-instructions-jina83en1-07-(2105) 31 / 108
ü
You have a separately available I/O module or bus module. See also "Accessories
[ } 101]".
ü You have a commercially available DIN-TS35 DIN rail.
1 Place the sniffer leak detector at least 20 cm away on all sides.
2 Connect the SL3000XL sniffer cable to the front of the XL3000flex.
3 Fasten the DIN rail using the screws already located in the threaded holes on
the back of the device (see Device setup [
}
14]).
4
Then hook the module into the DIN rail at the bottom, press it against the DIN
rail at the top and let it snap into place.
5
Connect the I/O module or the bus module via a data cable to the LD socket on
the back of the XL3000flex.
See also
2
Selecting the type of expansion module [
}
45]
2
Assigning analog outputs of the I/O module [
}
46]
2
Settings for bus module BM1000 [
}
53]
5.4 Fasten holder for sniffer line (optional)
WARNING
Danger to pacemaker wearers from magnets
The function of a pacemaker can be influenced by the magnet on the back of the
holder.
► If you wear a pacemaker, do not install it yourself.
► If you wear a pacemaker, always maintain a distance of at least 10 cm from the
holder when operating the device.
CAUTION
Risk of injury due to sniffer tip
► To prevent injury from accidental contact with the sniffer tip, align the sniffer tip in
the holder so that it points away from the operator.
A bracket is available for the sniffer tip. The holder can be mounted on the front of the
device, see also “Device setup [ } 14]“.