Industrex M43ic, Instruction Manual

Page: 35 / 51

Industrex M43ic / M43icN
page 29 01/2013 TK
Version 2.7 is equipped with a sub-program to control the filter unit of the developer:
Press the bottum
3
, use
6
to move the courser under "Options", press
7
, you
will see "Standby Refill Filter" use again
6
to move the courser under "Filter",
press
7
you will see:
The Area menu sets the amount of square meters before filter alert.
The value is 0000-9999 . A value of 0000 turns off the filter alert.
Filter alert
after xxxx sqm
Save Cancel
The Log menu shows the total area processed so far. This value is stored in the NVRAM.
The value is updated each time a replenishment is initiated. It depends on the „Replenish
after“ variable from the setup.
0000.00
Exit Clear
For example if Replenish after = 0.125sqm , the total processed area will be increased by
0.125 sq.m. at each replenishment.
At each replenishment the total processed area is checked for exceeding the alert value.
When the value has been exceeded, an error message appears „Change filter“.
After changing the filter, the user must go to programming mode menu Options/Filter/
Log and clear the processed area, so the area will be counted from 0 for the new filter.
5.12 FILTER CONTROL:
Area Log
WARNING: Call for qualified service personnel. The filter
may be exchanged by qualified service personnel only.