Industrex M43ic, Instruction Manual

Page: 27 / 51

Industrex M43ic / M43icN
page 21 01/2013 TK
5.2 CHANGING THE PROGRAM
To use another programme:
Press
5
.
You will see:
If media is being processed, only the Rep and Monitor items are selectable. Therefore,
to switch to another programme you must wait until the processor is empty.
With
6
,
move the cursor under P1.
Press
7
to change the programme number.
With
6
,
move the cursor to Use and select it with
7
.
Press
4
to jump back to main page
.
Note: a cyclic redundancy check is used to verify the data being read from the non-volatile memory.
If some damage occurred to the program data, or the programme was never set up properly,
you will get an error message Program invalid. The solution is to go to programming mode
and re-program the data. This error will occur also if the EEPROM chip has been replaced in
which case it contains random data.
Start P1 Use
Rep
Monitor