Impacts S210E, Operating Manual

Page: 32 / 48

S210E Operating Manual
30
Mounting:
Prior to mounting new liners, you should check the wheel housing and corners for wear.
1. Put the pressure screw (1) of the top liner in place.
2. Move the top liner (2) through the opening of the
wheel housing and turn it around the motor shaft
(6) into the upper part of the housing.
3. Place the side liners (3 & 4) inside the housing in
the same manner where the bolts can be pushed
through the holes in the side of the housing.
4. Put the screws (5) on the bolts and tighten them
slightly.
5. Slide the side liners (3 & 4) inside the housing
in a way that the liner sticks out approximately
2mm at the bottom of the housing. Fasten the
side liners with the screws.
6. Fix the pressure screw (1) where the edges of
the top liner is sitting on the upper edges of the
side liners.
7. Now mount the remaining components (A), as described in Chapter 7.5 - Mounting of the Blast
Wheel.
8. Finally, position the control cage as described in Chapter 7.4 - Adjusting the Blast Pattern.