Impacts S210E, Operating Manual

Page: 31 / 48

Operating Manual S210E
29
7.6 Adjusting the Magnetic Seals
The correct height of the magnetic seals is
important for the sealing of the machine and
vital for the airflow through the machine.
The adjustment height of the magnetic seals
should be set about 6-8mm on all sides and
parallel to the surface of the floor.
If the blast machine has to be used on very
rough surfaces, it may be necessary to set the
machine at the maximum height of 8 mm.
For the height adjustment you can use four
steel strips (2) of 8mm as shown in the picture.
Remove the brush seals (1) and put the strips
under the magnetic seals (3). Now loosen the
fixing screws of wheel bracket (4) and move the wheel bracket until the wheels touch the surface.
Then fix the wheel bracket again. If necessary you can lower the wheel bracket in the front (5) by
using additional distance rings. Then adjust the height of the brushes – that way the brushes (1)
slightly touch the surface.
7.7 Changing the Liners
Demounting:
The removing of the liners is only possible when the blast wheel is removed. Before you remove the
liners, remove the blast wheel and the wheel hub as described in Chapter 7.
1. Loosen the fastening screw of the left hand (3) and
right hand (4) liner, turning the liners toward the
inside of the blast housing and removing them out
the bottom of the housing.
2. Loosen the counter screw (2) of the pressure screw
of the top liner (5) and turn it completely up.
3. Loosen the pressure screw (2) of the top liner (5) to
the end and turn it back until you can remove it.
4. Put a small nail through the thread opening and
hit it down onto the top liner (5) until it slides
downward.
5. Turn the top liner around the motor shaft and take it
out through the bottom of the housing.
6. Take the top liner out through the bottom opening
of the housing.