IMDES CREATIVE SOLUTIONS Schulstrasse 21 D-48455 Bad Bentheim /Gildehaus Germany T:+49(0)5924-997337 E:
© 2019
IMDES CREATIVE SOLUTIONS
11
1.10 System Description
DINO-CONDENS-
IT
.
The
DINO-CONDENS-
IT
is intended to use for reflow soldering printed circuit boards on a smaller scale, i.e. for
individual pieces, prototypes and small series run.
It is specially designed to use for soldering of prototype PCB’s using BGAs, LGA’s components and stacked arrays.
Due the small footprint of the
DINO-CONDENS-
IT
, forced air cooling and single phase power, you will able to
use the unit at almost any that place.
After proper installation and operation,
DINO-CONDENS-
IT
will give high quality solder joints at all times.
Appropriate frequent checks and maintenance are required, due to the low GALDEN capacity.
Other applications than those described in this manual are not allowed!
1.12 safety Features:
1.12.1 Process chamber cover sensor.
A micro switch monitors if the process chamber cover is present and closed.
If you open the cover before the end of the process, the system is switched off.
When the there is no cover on to the process chamber, it is not possible to start the process.
1.12.2 Temperature Vapor/ ceiling height sensor.
1.12.3 Over heating sensor of heating surface temperature (fail safe)
A sensor/switch is mounted underneath the bottom of the process chamber to prevent overheating when there is
no heat transfer medium (fluid) at the bottom of the process chamber.
Caution!
In case of over temperature you must wait until the switch is closed again. Then you may fill the process chamber
with the transfer medium.
1.12.4 Cooling:
There is
ONE
large fan below the process chamber to cool the PCB and liquid in the chamber.
The height of the vapor in the process chamber is controlled by a thermal sensor
K-Element (T1) and a digital controller.
When the vapor maximum height is reached, the sensor automatically switches off
the heater and automatically starts the cooling process.
The end of the cooling process is reached when the fans have stopped.
