Configuration and Status Parameters
December 3, 2008
H A R R I S C O R P O R A TI O N
| I P A 68 0 0 + A S I O N I P V I D E O G A T EW A Y
Release 1.2.0 | Page 31
6.2.4 Utility Commands
6.2.5 Alarm Commands
Table 6-3 Utility Commands
Util
Description
Options
Default
Util/Clear
Clears and resets all status parameters.
Yes
This value is a momentary state. The module accepts this
value, clears all status values, and returns this parameter
to the ‘false’ state.
No
This value is the typical state for this parameter.
Yes, No
No
Util/Load Defaults
Loads factory default settings and resets module.
Yes, No
No
Util/Reset
Resets the module.
Yes, No
No
Table 6-4 Alarm Commands
Alarm
Description
Options
Default
Alarm/Eth/LOS
Indicates when Ethernet Link is lost.
Setting State: Enable, Disable
Status States: Active, Inactive
Priority:
1–10
On-Delay:
0–9999.9 (sec.)
Off-Delay:
0–9999.9 (sec.)
Ack:
Yes, No
—
Alarm/ASI [1–2] Input LOS
Indicates an ASI Loss of Signal (LOS) when the respective encapsulator’s LOS status parameter
indicates a ‘Fault’ state.
Setting State: Enable, Disable
Status States: Active, Inactive
Priority:
1–10
On-Delay:
0–9999.9 (sec.)
Off-Delay:
0–9999.9 (sec.)
Ack:
Yes, No
—
Alarm/ASI [1–2] Error
Indicates ‘Active’ when any of the following errors are reported on the respective encapsulator:
8b10bErrors increment
A transport stream is not ‘Not Present’
The ASi transmit rate falls to ‘0’.
Setting State: Enable, Disable
Status States: Active, Inactive
Priority:
1–10
On-Delay:
0–9999.9 (sec.)
Off-Delay:
0–9999.9 (sec.)
Ack:
Yes, No
—
Alarm/Encap [1–2] Error
Indicates the Encapsulator is in use and is dropping IP packets.
Setting State: Enable, Disable
Status States: Active, Inactive
Priority:
1–10
On-Delay:
0–9999.9 (sec.)
Off-Delay:
0–9999.9 (sec.)
Ack:
Yes, No
—
Alarm/Decap [1–2] No Input
Indicates the decapsulator’s transport stream rate has fallen to zero.
State:
Enable, Disable
Priority:
1–10
On-Delay:
0–9999.9 (sec.)
Off-Delay:
0–9999.9 (sec.)
Ack:
Yes, No
Alarm/Decap [1–2] Uncorr Error
Indicates the decapsulator is experiencing uncorrectable errors.
Setting State: Enable, Disable
Status States: Active, Inactive
Priority:
1–10
On-Delay:
0–9999.9 (sec.)
Off-Delay:
0–9999.9 (sec.)
Ack:
Yes, No
—
