December 3, 2008
H A R R I S C O R P O R A TI O N
| I P A 68 0 0 + A S I O N I P V I D E O G A T EW A Y
Release 1.2.0 | Page 23
Chapter 5: Operation
5
5.1 How Commands Are Documented for Both Craft and Navigator
In +Pilot or Navigator, each element in this command line represents a distinct level in the command tree. The last element in the command line
represents a parameter value selection or entry.
Procedures in this chapter list commands in a single-line format.
Configuration/Ethernet/IP Address = 123.123.123.123
An expansion of this example instruction would appear as follows.
1
Select the ‘Configuration’ branch in +Pilot or Navigator,
2
Select the ‘Ethernet’ branch.
3
Choose the ‘IP Address’ parameter.
4
Set the ‘IP Address’ parameter to ‘123.123.123.123’.
See the following documents for information on how to operate this product remotely:
•
+Pilot Lite User Manual
for serial interface
•
CCS Pilot, CoPilot, Navigator, or RCP-CCS-1U Remote Control Panel manual for Ethernet interface
5.2 Navigator Configuration Recommendation
We recommend the following setting in Navigator to ensure fast and accurate communication with the .
1
In Navigator, choose “Options > Control” to open the ‘Control Options’ dialog.
Figure 5-1 Control Options Dialog
2
Check the ‘Device parameter changes as slider is released’ radio button.
3
Click the ‘OK’ button.
