Page 30
Setup Manual
C.2 Assembling the Floor Stand
Start with a crossbeam (component #1), a vertical leg (component #2 or #4), and a
crossbeam foot (component #3).
Note:
The three holes on the vertical legs (component #2 or #4) must be placed
−
at the side where the crossbeam will be mounted,
−
in the upper part of the vertical leg.
The drawing in Picture 17 illustrates the correct position.
The two holes with threaded bushes of component #4 (marked with red circle) will be used
to hold the monitor mount. They must be positioned at the outside.
Picture 18: Assembly steps
Step A
: Insert a vertical leg (#2 or #4)
into a crossbeam foot (#3). Each
crossbeam foot has a cutout for the
vertical leg.
The crossbeam feet are designed
symmetrically, therefore they fit on the
left and the right side.
Step B
: Insert the lower crossbeam
(#1) in the combination of vertical leg
and crossbeam foot.
Picture 19 shows the result of step A and step B.
Picture 19: Lower crossbeam combined with foot and vertical leg
Summary of Contents for Wide Tek WT 36C
Page 1: ...Setup Manual...
