IMA RSW.04, Installation Manual

Page: 7 / 24

IMAporter Reader with MobileAccess function – installation guide
7/24
Demo Configuration Cards :
•
Wiegand 26bit + RS232
•
Wiegand 32bit + RS232
•
Wiegand 56bit + RS232
Demo Access Cards :
•
MIFARE Classic 1k (UID reading)
•
MIFARE DESFire (File: 0; No: 65534; Key: 12345678901234567890123456789012)
Mobile devices :
•
Android 4.4+ NFC / BLE devices with IMAporter Mobile Key app installed (link on last page of this
manual)
•
iOS 7+ BLE devices with IMAporter Mobile Key app installed (link on last page of this manual)
All configuration cards are set to use the following settings :
•
Wiegand output according to card description:
o
Wiegand 26: 1 bit parity, 24 data bit, 1 bit parity
o
Wiegand 32: without parity
o
Wiegand 56: without parity
•
RS232 output:
o
Broadcast length: 32 bits
o
Baud rate: 9600, 8bits without parity
o
Format: ASCII
•
Accepted ID media:
o
MIFARE Classic 1K - UID reading
o
MIFARE DESFire - File reading (according to specification above)
o
NFC media – UID reading
o
NFC devices - needs to be set using IMAporter Reader Config app
o
BLE devices (if supported by HW) - needs to be set using IMAporter Reader Config app
4.2.3 Reader configuration using a configuration card
Connect the reader to the control unit and power it up according to chapter
3.3 - Reader connection –
wiring scheme .
New or Factory reset reader
If you are configuring a new or a recently reset reader, it will start blinking red LED in 1sec interval.
Apply a configuration card and hold it at the reader for 5sec. During configuration download, the reader
shines green LED for about 3sec. After that it shortly blinks red LED. In case that identification using
mobile devices (NFC or BLE) was not allowed, the reader switches to normal operating state in which it
behaves according to the settings of the master control unit.
In case that NFC or BLE identification was allowed by the configuration card, the reader continues to blink
red LED in 1sec interval and waits for setting up using the IMAporter Reader Config app (described in
chapter
4.3 Setting up using IMAporter Reader Config ).
Reconfiguration of a working reader
To change configuration of an already configured and operated reader, factory reset is not necessary. To
reload the reader with a different configuration, restart the power (switch the reader OFF and ON again)
and apply a new configuration card in the first 10sec after start-up. Hold the card at the reader for 5sec.