IMAporter Reader with MobileAccess function
–
installation guide
6/24
4
Configuration, reconfiguration and getting into
operation
This chapter describes the procedure of reader configuration for cases when the reader has not yet been
configured, is missing part of its configuration or needs to be reconfigured with new settings.
To erase current configuration or
change system settings of MobileAccess function
, it is necessary to
proceed with factory reset of the reader according to chapter
4.1 Restoring factory settings (factory reset)
4.1
Restoring factory settings (factory reset)
Sometimes it is necessary to restore factory settings of a reader. Such circumstances may occur when we
need to change system settings (system ID / Porter key) or after FW upgrade. Factory reset deletes all
configuration and data stored in the reader.
Resetting IMAporter Reader (RSW.04 or RSW.04-B)
1.
Power the reader OFF
2.
Short
black, pink, brown
and blue wires (ground the signalization wires)
3.
Power the reader ON
4.
The reader will start blinking red LED in 1sec interval and will not accept any ID media or
communicate with mobile devices, Bluetooth signal will not be visible
5.
Disconnect the wires and reconnect to the control unit
6.
Continue with reader configuration using a configuration card
NOTE
: If the wires remain shortened, the reader will factory reset each time the power goes down!
4.2
Reconfiguration using a configuration card
A configuration card is used for setting the basic parameters of communication protocols, accepted
identification media, indication options etc. according to chapter
4.2.1
Delivery and preparation of configuration cards
Configuration card with configuration agreed upon with the customer is usually supplied together with the
IMAporter Reader. Configuration cards are prepared and supplied by the system manufacturer or
authorized distributors.
4.2.2
Demo configuration cards for reader testing
For initial testing of the IMAporter Reader, it is possible to order a reader with a set of 3pcs DEMO
Configuration Cards prepared with various communication protocols and 2pcs of identification cards for
testing the correct system functions.
NOTE
: DEMO configuration cards can be used only to configure readers ordered as a DEMO reader. These
cards cannot be used with ordinary readers and at the same time a DEMO reader cannot be set using
common configuration cards. For more information about reconfiguration of a DEMO reader, please
contact the supplier or manufacturer.
