IMAporter Reader with MobileAccess function
–
installation guide
4/24
Power supply / max. consumption:
12
–
15 VDC / 200 mA
IP Rating:
IP 65
Housing:
plastic (ABS)
Color:
black with exchangeable front sticker
Temperature range:
-
25°C to +60°C (
-
13°F to 140°F)
Wiring:
2x power, 2x communication, 1-3x indication, 2x tamper contact
Cable:
Pigtail, cable LiYCY 12x0, 14 mm
2
, 3m
Cable Distance:
Wiegand:
150 m (500 ft.),
RS232:
30 m (100 ft.)
Reader dimensions:
Height
Width
Depth
Standard housing
11,7 cm
(4.6“)
5,0 cm
(2.0”)
2,0 cm
(0.8“)
Only PCB
8,5 cm - 10,5 cm
(0.0”)
4,5 cm
(0.0”)
1,1 cm
(0.0”)
Antenna dimensions:
Height
Width
6,0 cm (2.36
”)
4.5 cm (1.77
”)
3.2
Configuration options
Reader configuration is carried out using a configuration card. Configuration steps are described in chapter
4. Configuration, reconfiguration and getting into operation
Communication interface:
only Wiegand / only serial line RS232 / both (different wires)
Wiegand settings:
26bit* / 32bit / 56 bit / (other can be ordered)
Wiegand 26 is 24 bit + parity bit on the beginning and at the end
Wiegand 32 and 56 is without parity
* Wiegand 26bit is not suitable for systems reading UID from RFID cards as duplicated may occur (card UID
required a longer Wiegand transfer).
RS232 output:
Broadcast length:
32 bits / 64 bits
Baud rate:
9600 / 19200 / 15200 (8bits without parity)
Format:
ASCII / HEX
Reading options:
standard
(number is broadcasted as read from card)
reverse
(number is broadcasted in reverse order by bytes)
Reading signalization:
LED blinking
: on / off
Beeper
: on / off
LED control:
two-wire
(green and red LED are controlled separately)
one-wire
(green LED is controlled, red LED shines continuously)
Accepted ID media:
MIFARE Classic:
UID / sector
MIFARE DESFire:
UID / file
NFC media:
UID
NFC device:
PIN: yes / no
Bluetooth LE device:
PIN: yes / no
