IHI IC75, Operation Manual, Page: 100 / 106

MAINTENANCE
IC75 ENG 4-36
LONG TERM STORAGE
Before Storage
IMPORTANT
Move the body down to the lowest position while
storing in order to protect the cylinder rod from rust.
To store the machine from long term, follow the next
procedures.
1. Clean parts of the machine.
2. Be sure to perform fill the fuel, lubrication, and oil
change.
3. Select a well-drained, dry and well-ventilated flat place.
Put plates on the ground.
4. Store the battery after remove the negative terminal
and covering it or dismounting the battery from the
machine.
During Storage
WARNING
If you have to operate the machine indoors to
prevent rust, keep good ventilation and gas
poisoning by window or entrance.
1. During storage, operate the machine once a month to
maintain films of oil at the lubrication section and
charge the battery at the same time.
2. Before starting the engine, be sure to crank the engine
with the starter and make sure that the engine oil
pressure warning lamp goes out.
3. Warm up the engine at low speed. Increase the
engine speed after the water temperature reaches the
proper temperature.
After Storage
Lubricate or grease every necessary part, check the
coolant level and refill coolant if necessary, before using
the machine after long-term storage.
Position for long term
storage