The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using it for any purpose other than the use of the products or the
execution of the project to which it refers, and from communicating it to third parties without Au
tomatic Systems’ prior written agreement. Document subject to change without notice.
BL5x-MT-EN-13
page
47/56
--
If the case occurs, mount the shrouds on the new arm referring to paragraph
[4.5. Fixing the shrouds]
.
--
Make the necessary adjustments referring to paragraphs
[4.7. Levelling the barrier arm]
,
[5.1. Arm
balance adjustment]
and
[5.3. Safety torque limiter adjustment]
.
Notes
:
-- If you install an accessory on the barrier arm (road sign, traffic lights, etc.) or remove one, refer
to paragraphs [4.7.], [5.1.] and [5.3.] to re-adjust the arm balance.
-- Should the shaft be replaced, please contact your local
Automatic Systems
agent for further
information.
-- To replace the spring, follow the procedure described here above (same paragraph 5.5).
-- If the mains frequency is 60Hz, you may have to change the pulley/belt combination. If
necessary, contact your local
Automatic Systems
agent.