The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using it for any purpose other than the use of the products or the
execution of the project to which it refers, and from communicating it to third parties without Au
tomatic Systems’ prior written agreement. Document subject to change without notice.
BL5x-MT-EN-13
page
27/56
4.2.
Handling and installing the unit
The barrier has been packaged in a wood crate for transport. Carry the material to the installation site with
the help of a trolley or a crane (according to the site configuration), place the crate upright and dismantle.
Unlock and remove the side doors (
1:1
) and (
1:2
). Keys are attached on the arm bracket (
1:4
) or (
1:5
) by
means of adhesive tape.
Unlock the two latches (
2:12
) from inside and remove the hood (
1:6
).
Check the state of the equipment. Though it has been carefully packed, damage may have occurred during
transport: in this case, do not forget to advise your local
Automatic Systems
agent or your insurance
company. If need be, proceed with the necessary repairs.
Strip the insulation of the cables along approx. 50cm.
Locate the hole (
1:10
) of the emergency crank (
1:11
).
Without damaging the anchoring bolts, place the housing (
1:7
) on its concrete base so that the crank hole
is at the same side as the roadway.
Insert the two fixing brackets (
1:8
) inside the unit onto the anchoring bolts (
6:1
) of the basement kit.
Secure the barrier to the basement kit by locking the fixing brackets (
1:8
) with the flat washers (
6:5
), the
lock washers (
6:6
) and the nuts (
6:7
).
Fix the stainless steel heater (
2:11
) into the sheath provided behind the gearbox console, below the
technical identification plate (
2:6
).
If required, add shims between the sealing frame and the housing in order to ensure the barrier is perfe ctly
level.
Note
:
Since final adjustment of the alignment with the roadway may be necessary after the arm is
installed, do not tighten the nuts (
6:7
) firmly now.
