The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using it for any purpose other than the use of the products or the
execution of the project to which it refers, and from communicating it to third parties without Au
tomatic Systems’ prior written agreement. Document subject to change without notice.
BL5x-MT-EN-13
page
34/56
4.7.2. Vertical position "open"
The mechanism is in "open" position if the crankshaft is flush with the open stop screw (without
pressure).
If the arm is not in vertical position, proceed as follow:
Unscrew the nut of screw (
12:5
), without dismounting it.
Loosen screws (
12:7
) maintaining the "angle corrector" plate (
12:6
).
Move this late millimetre by millimetre, towards the shaft if the arm has passed over the
vertical position, or away from it if the arm has not reached the vertical position.
Warning
:
After this operation, bring the mechanism in closed position and check once more the
horizontal position of the arm. The adjustment operations must be repeated as much
as necessary to reach precise positions, when opening and closing the arm.
Note:
This "angle corrector" allows also to reduce or increase the 90° angle and to align the arm with a bending road.
