IEMCA SIR 52 F, Manual For Use And Maintenance

Page: 55 / 174

5 - ADJUSTMENTS AND SETTING-UP SIR-52-P/F
EN
5 - Pag. 5 / 26
5.2.2 Pressure foot - Adjustment
Hexagonal and round bars
Regulate the pressure foot (A) height so that the
nut (B) stays at a distance of 0,5÷1 mm from the
limit stop when there are some bars under the foot.
Adjustment is carried out operating nuts (B)
Horizontally adjust the pressure foot position, in
order to cover completely the bars in the selection
area, thus allowing a certain number of bars to
dwell whenever the stock tube lifts and unloads
bars.
Use screws (C) holes and/or the double holing (D)
to carry out the adjustment.
Should it be necessary, operate screws (E) so that
the pressure foot plane is parallel to the belt plane.
Square bars
Regulate the pressure foot (A) height so that the
nut (B) stays at a distance of 0,5÷1 mm from the
limit stop when there are some bars under the foot.
Carry out the adjustment operating nuts (B).
The foot position must allow the first bar (F) to lift;
as far as adjustment is concerned, use screws (C)
holes and/or the double holing (D).
Whenever necessary, operate screws (E) so that the
pressure foot surface is parallel to the belts surface.