Operation of CW-F25
GPI connection - as tally
37
7.
Set the radio frequency in the setup menu of the transmitter.
P.49 "Setup menus - Transmitter"
8.
Setting the GPI function in the setup menu of the transmitter.
Tally > Tally mode > Remote or Link Status Select one.
Each function is described below.
Remote
Contact signal input to the receiver will be transmitted and
output from the transmitter.
Contact signal means; open=off / short=on.
Link Status
Outputs the state of the wireless connection.
Disconnect: open,
Waiting: open/short alternately (flashing),
Connect: short
* Default setting is Remote.
Last setting is memorized even after power is turned OFF.
9.
Setting the GPI function in the settings menu of the receiver.
Tally > Remote Tally > ON or OFF Select one.
ON means a GPI input is enabled. OFF is disabled.
* Default setting is ON.
Last setting is memorized even after power is turned OFF.
Cable and connector
GPI connector is two-pole mini jack.
Please refer to P. 70 "Connector and pin assignment".
Please prepare GPI cable, locally.
