References
Setup menus - Receiver
58
Network setup > Gateway
Setting IP gateway
Items
Enter IP gateway address.
Enter IP address of gateway. Default value is 192.168.98.1.
Setting changes are not required if a router or IP gateway are not used.
Power cycle to allow changes to take effect.
Network setup > Codec Local IP
Setting IP address (2)
Items
Enter IP address.
Enter the codec module IP address which is built in the unit.
The Default IP address of the receiver is 192.168.98.111. Please change if it overlaps
with existing equipment on the LAN. Power cycle to allow changes to take effect.
Note:
Must be same subnet as "Setting the IP address (1)".
For example.
Setting of the IP address (1): 192.168.111.20 Netmask 255.255.255.0
Setting of the IP address (2): 192.168.111.21
Network setup > Codec Remote IP
Setting IP address (3)
Items
Enter the IP address.
Enter the codec module IP address which is built in the transmitter.
The Default IP address of the transmitter is 192.168.98.112. Please change if it overlaps
with existing equipment on the LAN. Power cycle to allow changes to take effect.
Important:
Please set same address as Codec Local IP of transmitter side.
If the setting have two different IP addresses, the system will not link .
Video > Return video
Setting return video
Items
ON / OFF
Set ON/OFF of return video transmission.
ON: Return video transmission is enabled.
OFF: Return video transmission is disabled.
Video > Embedded audio
Setting embedded audio
