IDTECK Star iCON100SR, User Manual

Page: 59 / 90

p.53 Setup Menu F2
The 14.Duress mode setting allows you to decide the output signal time for when
access is granted following a duress event.
When a particular event occurs, the iCON100 will generate an output signal for Re
lays #1 and #2, TTL #1 and #2, and Buzzer for the length of time defined for each.
2.6 Output Time Setting
Output Time Set allows you to define the unit of time.
1 sec
Output Time is calculated in the time unit of 1 second for the In/Output definition.
0.1 sec
Output Time is calculated in the time unit of 1/10 second (or 100ms) for the In/Outp
ut definition
To change the setting, press <ENT> and press <4> or <6> to select the desired time unit and
press <ENT> to confirm.
Output Time Setting Examples
e.g. If you want to activate the Relay#1 (OUT #1) for 3 seconds;
- The Time Unit should be set to “03” for Relay#1 in the menu “1. EXIT”.
- Set to 1Sec in the menu ‘OUTPUT TIME SET”
e.g. If you want to activate Door Relay#1 (OUT #1) for 0.3 seconds;
- The Time Unit should be set to “03” for Relay#1 in the menu “1. EXIT”
- Set to 100ms in the menu “OUTPUT TIME SET”