IDTECK Star iCON100SR, User Manual

Page: 18 / 90

PRODUCT OVERVIEW p.12
3 8PIN DIP Switches
These switches are to set board ID and baud rate to communicate with PC. (#1~#5 DI
P switches for board ID, #6~#8 DIP switches for baud rate)
4 Initialization Switches
These switches are to initialize user data in the memory. To be default setting by Initia
lization, press the two switches simultaneously then keep pressing more than 2 secon
ds to initialize properly.
5 RJ45 LAN port
This port is to connect RJ45 LAN cable for communicating with PC.
6 LED
This is to show the status of LAN communication
7 RL #1 ~ #2 Ports
These ports are connected to control signal line of buzzer and LED of the reader. It is
used to show operating status for the reader during operating RL#1 and RL#2.
8 Input #5 Port
This is the Input #5 port. LED is turned on when Input signal is perceived.
9 Input #4 Port
This is the Input #4 port. LED is turned on when Input signal is perceived.
10 Input #3 Port
This is the Input #3 port. LED is turned on when Input signal is perceived,
11 Input #2 Port
This is the Input #2 port. LED is turned on when Input signal is perceived.
12 Input #1 Port
This is the Input #1 port. LED is turned on when Input signal is perceived.
13 MCU Module connecter
It’s the terminal for MCU module connection.
14 IIM7100A Connector
It’s the terminal for IIM7100A(Optional) connection.
15 Reader #2 Port
This is the port to connect reader #2.
16 Reader #1 Port
This is the port to connect reader #1.