Idex Hale Sam, Operation Installation Maintenance Manual

Page: 22 / 141

8
2.1 SAM Numbering and Specifications References
SAM system only comes as part of a Hale pump kit or a Hale module and is therefore identified
by the associated pump ID plate. Figure 1 shows the typical ID plate used on the Hale SAM.
Figure 1. Hale ID Tag With Sample Markings
The ID plate is stamped with the appropriate model, capacity (NFPA rated) code, drive unit code,
and serial number at the factory during manufacturing/testing. (Refer to the Pump Identification
paragraph in the OIM Manual for the applicable Hale pump.) The pump ID plate is permanently
attached to the associated Hale built pump module if the pump was ordered as part of a Hale
built module, otherwise it is shipped loose with the SAM pump kit.
NOTE
Using your pumps serial number and the Hale website (or calling Customer Service) is
the best way to ensure you receive/utilize the correct replacement parts for your pump
and SAM system.