IDEAL FAST-WAY Si-Low 210 A1, Owner'S Manual

Page: 9 / 149

7
Si-Low 210-A1
SET UP PROCEDURE
1. Select a level site with solid footing for setting up and operating cement silo.
2. Block tires, to keep cement silo from moving, before unhooking tow vehicle..
3. Unhook tow vehicle, move vehicle away from cement silo.
4. Remove keepers from both leg pins at rear of cement silo. Slowly remove leg
pins. CAUTION! Inner leg will fall to ground; STAY CLEAR WHEN
REMOVING LEG PINS! See page 23.
5. Using side-wind tongue jack, lower front end of silo until leg pins can be
installed in second hole in rear legs.
6. Install leg pins through holes in both rear legs; install keepers.
7. Remove keepers from both leg pins, at front of silo. Slowly remove leg pins
CAUTION! Inner leg will fall to ground. STAY CLEAR WHEN
REMOVING LEG PINS!
8. Using sdie-wind tongue jack, raise front of cement silo until leg pins can be
installed in second hole in front legs
9. Install leg pins through holes in both front legs; install keepers.
10. Using sdie-wind jack, lower front of cement silo until all weight is off jack.
11. Check cement silo for level and stability. Correct as needed..
12. Connect electric power to disconnect box at rear of cement silo, using
qualified person See page 2 and 3 for diagram. Check for proper rotation of
Auger. Correct as needed.
13. Connect air supply to valve. Silo fluidizer aerators require 10.2 CFM @ 90
PSI with a 60 gallon tank. See drawing #110 on page 25.