IDEAL FAST-WAY Si-Low 210 A1, Owner'S Manual

Page: 12 / 149

10
Si-Low 210-A1
OPERATING PROCEDURE
A. CHARGING SILO
1. Close silo discharge gate, (REF# 1)
2. Air pump cement through filler pipe, (REF# 5))
3. You must open ball valve on side of bag-house to operate vibrator to clean
filter bags each time after filling silo. (REF #6). Vibrator requires 4.5
CFM @ 60 PSI or 5.5 CFM @ 80 PSI. Or open side doors and manualy
shake bags.
4. Open cleanout gate, at bottom of bag-house hopper, remove over flow
cement from hopper; close gate. (REF #6)
B. AUGER OPERATION
1. Raise disconnect handle on electrical panel to ON position. (REF #3).
2. Open discharge gate. (REF#1)
3. Turn air supply on. (Supplied by customer)
4. Open ball valve on aerator system for one minute.(REF# 4) Close ball
valve. If optional pulse system is purchased turn air valve control to ON
position. (REF# 3). (Optional)
5. Push start button, (REF # 3). Auger will start. Turn vibrator on. Optional
aerators will pulse on for three seconds, off for seven seconds, until stop
button is pushed.
NOTE: If slower delivery of cement is needed; close discharge gate to
get desired amount.
6.
Fill unit with cement.
7. When unit is filled push stop button, and turn vibrator off. (REF #3)
8. Close discharge gate. (REF # 1).
9. Lower disconnect handle on electrical panel to OFF position. (REF #3).
10. NOTE: The auger should be emptied on last load of the shift. Discharge
boot should be rolled up and secured to keep moisture out of auger tube to
prevent build up on auger screw.