IDEAL FAST-WAY Si-Low 210 A1, Owner'S Manual

Page: 8 / 149

6
Si-Low 210-A1
PREPARING SILO FOR TRANSPORT
1. Most important is to be positive that all cement has been removed from silo, auger
and bag-house.
2.
Using a rubber mallet, hit the sidewalls of hopper section of silo; listening for a
hollow sound. Clean out remaining cement. A bag of floor dry will aid in cleaning
out the auger by opening the manhole on top of the silo, pour the floor dry inside of
the cement silo. Turn auger on, open discharge gate. Run auger until the floor dry
no longer comes out of discharge end of auger. Turn auger off and close discharge
gate.
3. Disconnect air supply.
4. Disconnect electrical supply. CAUTION! Only a qualified person should do this.
5. Using side-wind tongue jack, raise front of cement silo until all weight is off both
front legs...
6. Remove keepers from both front leg pins, slowly remover leg pins. CAUTION! Inner
leg will fall to ground. STAY CLEAR WHEN REMOVING LEG PINS.
7. Using handle on leg pad, raise leg until pin can be installed in first hole. Install leg
pin through hole, install keeper. Repeat on second leg at front of cement silo.
8. Using side-wind tongue jack, lower front of cement silo until all weight is on both
rear legs.
9. Remove keepers from both leg pins; slowly remove leg pins. CAUTION! Inner leg
will fall to ground. STAY CLEAR WHEN REMOVING LEG PINS!
10. Using handle on leg pad, raise leg until leg pin can be installed in first hole. Install
leg pin through hole and install keeper. Repeat on second leg at rear of cement silo.
11. Using side-wind tongue jack, raise front of cement silo until tow vehicle can back
under pintle hitch.
12. Back tow vehicle under pintle hitch, using top-wind tongue jack, lower front of
cement silo onto tow vehicle hitch, secure latch. Hook safety chains and break-away
cable to tow vehicle. Plug in lights, check lights for proper operation.
13. Raise top-wind jack to full up position. See drawing (Adjustable Legs) on page 23.
14. Clean all debris of silo before towing.