2
M12 - Setup
To change between shielded & unshielded cable, toggle Beeper to select
length units.
When in SETUP mode -
• Use Up or Down arrow keys and scroll
to Shielded and Unshielded, press
SELECT to change.
• Selectable Pass Beep-On and Pass
Beep-Off function is also available in
this SETUP mode, press Up or Down keys to select and press SELECT to
choose. (Note: Beeper sounds when test passes, and when voltage is
detected on a cable.)
• In this mode, press Up and Down keys to select between units of length,
Units-feet or Units-meters, press SELECT key to select.
M12 – for 2-pair data cable test
Test in Progress - Cable Test
1. When the test is running, “Test” blinks;
when test is completed, “Pass” or “Fail”
shown;
2. Remote ID shown when wire map
passes;
3. The last line shows the length of cable being tested;
4. Beeper icon appears only when Beeper is OFF; low battery icon appears
only when the battery is below 5.5V
Results of a corectly wired shielded cable
1. When the test is running, “test result
shows “Pass”;
2. Remote ID shown when wire map
passes;
3. The last line shows the length of cable
being tested;
4. Beeper icon appears only when Beeper is OFF; low battery icon appears
only when the battery is below 5.5V
SETUP
Unshielded
SEL to change
Test
M12
1234 No Shield
1234 ID 1
1.5m
PASS
M12
1234 Shielded
1234 ID 1
1.5m
PK Elektronik Vertriebs GmbH, E-Mail: [email protected], Internet: www.pkelektronik.com
