IE Net PRO Cable Tester
Eight modes of operation
1. DATA – cable test mode
5. HUB BLINK
2. COAX (RJ45) – cable test mode
6. Set up Mode
3. LENGTH – Cable length measure
7. OFF
4. TONE
8. Voltage Protection
Press
MODE
to select any of the seven modes of operation, press
SELECT
to
enter selected operation mode and proceed,
Press
SELECT
for two seconds to turn backlight on/off.
DATA – Data Cable Test
1. Press any of the four keys to power on
the tester; when powered on, M12,
M12>RJ45, RJ45 shows on the first
line of the screen;
2. M12 is the default setting; use Up or
Down arrow keys to select M12>RJ45
or RJ45
M12– for 2-pair data cable test
When in M12 mode and no cable is
connected, the display shows:
1. When in M12 mode “No shield” is
default setting
2. Exit to SETUP to change options
(see Set Up mode)
3. When using M12 mode, the Split Pair
function is automatically disabled.
Standby - Cable Test (Pre-Test)
1. When in M12 mode,
2. Connect cable to the Tester (see
following screens for more
demonstrations )
Note: When there is no Remote
connected, Shield and No Shield will
not appear)
33-772
M12 M12>RJ45 RJ45
to change type
MODE=ESC
, SEL=go
Test
M12
1234
Open 1-3 2-4
Displays and cycling in sequential order
1-3, 2-4, No Cable
Test
M12
12 34
Pass Pre-Test
15.5 ft
Cycling in sequential order
1 2, 3 4
PK Elektronik Vertriebs GmbH, E-Mail: [email protected], Internet: www.pkelektronik.com
