18
CONFIGURE
7.0 SYSTEM CONFIGURATION
5. In certain situations, it may be necessary to
enable the repeater function on selected Luminaire
Controllers to extend the wireless range of your
Audacy Wireless Controls system. In order to do so,
perform the following steps.
a. Select room in which the desired Luminaire
Controller will be enabled as repeater.
b. Select the Luminaire Controller.
Once all the devices are assigned to a room, the control devices such as switches, light sensors* and motion sensors need
to be associated with the Luminaire Controllers they will control.
7.1 ASSOCIATING DEVICES
7.0 SYSTEM CONFIGURATION
1. Click SETUP.
2. Select the desired room in which devices need to be
associated.
3. For each control device in the room, place a
checkmark next to each Luminaire Controller you
want that device to control (for example in the image
above, “Elm Handheld” is configured to control
Fixture Zone-9b-1 and Zone-9b-2).
4. Click SAVE.
c. Click to access settings and enable repeater.
NOTE: It is not recommended to enable the repeater function
on all Luminaire Controllers. Enabling more repeaters
than necessary may have a negative impact on system
performance. A maximum of 5 repeaters may be enabled per
Gateway.
*NOTE: Once a minute, the Light Sensor will send a light level reading to the Gateway. The Gateway will process the reading and if it is within the acceptable window of upper and
lower light levels as indicated by the slider setting on the Audacy Interface, no change will happen. Once light in the space, due to daylighting, moves above or below these set points
the luminaire controller in the space will adjust the lights accordingly. If current light level is above the daylight upper limit, then the controller will reduce the lighting in the space, and
when the light level is below the daylight lower limit, the controller will increase the lighting in the space. The lighting will adjust in 5% increments (or 20 steps from 100% to 0%) at
each minute while the light level is outside the desired lighting band.
Summary of Contents for Audacy Wireless Controls
