IDEAL INDUSTRIES Audacy Wireless Controls, User Manual, Page: 8 / 48

8
INSTALL 3.0 SYSTEM SETUP
1. As switches and sensors are installed remove one of
the labels with the unique serial number and attach it to
the Device Tracking Form included in the Appendix to
record the location of each device.
2. The sensor must be activated by pressing a small
button underneath the label on the back side of the
sensor.
• This can be accomplished by using a paperclip, the
screw that is included with the sensor, or similar object
to push through the label and depress the switch.
3. Find a suitable location for the sensor based on the
specifications shown in the sensor coverage pattern in
the Appendix p. 42-46.
For optimal performance:
• Make sure the sensor has a line of sight to the occupant
in the space.
• Plan on a 8’ radius of coverage when mounted on a 9’
ceiling (extended coverage for high bay or wide range
versions).
4. Mount the cradle in the desired location via screws,
ceiling tile wire (included) or double-sided tape.
5. Insert the sensor into the cradle.
• If desired, the sensor can be secured to the cradle
by aligning the holes on the sensor and cradle and
inserting the screw provided through the cradle and
into the sensor.
3.2.4 SWITCH AND SENSOR INSTALLATION
Motion Sensors and the Remote Switch require no wiring and detect occupancy/vacancy. Light Sensors also require no
wiring and are used for daylight harvesting. These devices are engineered to provide maintenance-free battery life.
Note: When the sensor hasn’t detected motion for the time specified in “vacancy timeout” the lights will flash 60 seconds prior
to turning off as a warning.
As a reminder, keep track of serial numbers as described in Section 3.1.1.
3.2.5 WALL-MOUNT AND SCENE SWITCHES
Wall–Mount and Scene Switches fit into decorator-style faceplates and can
be used to replace an existing switch.
As a reminder,
keep track of serial numbers as described in Section 3.1.1.
1. As switches are installed
remove one of the labels with
the unique serial number
and attach it to the Device
Tracking Form included in
the Appendix to record the
location of each device.
2. The switch must be activated
by pressing a small button
recessed on the back side of
the switch.
• This can be accomplished
using a paper clip or similar
object.
3. Remove existing switch and
properly terminate any pre-
existing wires.
4. Use screws to secure the
flush-mounted switch to the
electrical box.
5. Cover with a decorator style
faceplate.