Innovative Circuit Technology Ltd.
40
d. Enter the local IP address of the power supply (e.g.
192.168.0.181
) in the IP Address
field. The current IP
address of the power supply can be found on the Network
Status screen (see the Control Panel Menus section for more
information).
e. Check Enable, and then click on Save Settings.
NOTE:
port 80, you will need to change the HTTP port the panel uses from
80 to something else, such as 8000. Valid port numbers are in the
range of 1 - 65535. See the Network Setup
section for instructions on
how to change the power supply network ports.
You will also need to change the HTTP port number from 80 to
something else if your local network already contains another device
using port 80 such as another panel or a Web server.
3.
To configure HTTPS forwarding, repeat steps 2a 2e with the
HTTPS port number that the panel is using. If you are using the
default panel port settings, the HTTPS port number is 443.
4.
Before you can access the panel over the Internet, you will need
to know the WAN IP address of the router, which is assigned by
your ISP. With the Linksys WRT54G router, this information is
NOTICE!
If you are using a Dynamic IP address, your WAN IP
Address may change from time to time without warning, depending
on your ISP. You may want to obtain a Static IP address from your
ISP, which will be more convenient to use to access the panel from a
remote location. A Static IP address is a fixed IP address that will not
change. Alternatively, if a Static IP address is not available, you can
use a Dynamic DNS service such as DynDNS.com (see
www.dyndns.com
).
To access the panel over the Internet, type the WAN IP Address
of the router in the location/address field of your browser, followed
by a colon and the HTTP port number that the panel is using (e.g.
http://209.123.10.33:8000
for IP Address
209.123.10.33
, Port
8000
). The Web server panel should then appear, as shown
below: